Here at Turbo Technology, we have DynoJet 2wd Dyno. Over the years we have done an enormous amount of tuning on a wide range of vehicles on a wide range of tuning platforms. From 2 cylinders to NHRA, from engines cranked by hand, to today’s high horsepower - high performance street machines.
For $70 we will hook-up your front or rear wheel drive vehicle and do a single pull to give you a precise measurement of the rear wheel horsepower and torque output of your vehicle. Any additional pulls cost $10
For an additional $45 we will hook up the dyno’s O2 sensor to measure the exhaust’s air fuel ratio to be able to tell you whether your vehicle is running rich or lean and data log it through the rpm range. This provision is available only if you have an additional O2 plug already welded into your exhaust system. If needed, we can arrange to weld one into your exhaust and cap it with a plug when finished. This charge varies on different vehicles, but averages around $60 with the plug. We do have tailpipe sniffer capabilities as well, but if a catalytic convertor is present, the reading will be skewed.